![background image](http://html1.mh-extra.com/html/wafer/dc200/dc200_manual_3120481009.webp)
WAFER GSM-KEY-DC REMOTE CONTROL UNIT
http://www.waferstar.com
COM Port parameters config interface and connect to the device
Before program the device through the PC,firstly you need to config the COM port paramters and
then connect the device to PC software.
Password is the PWD password, if no change,the initial password is “ 123456 ”
In the is program mode selection area, you have three type of the program mode to select
according your program adapter ordered ( you can confirm it from the following program adapter
pictures list )
1.
Nomal program mode (RS232 program adapter and USB program adapter)
No selection of box of the RF-KEY mode and use modem
Input the right password,initial password is “ 123456 ”
2.
RF wireless program mode ( RF program adapter )
Check the select box of the RF-KEY mode
Input the ID number of your device and password. This mode is only for the GSM-RFKEY
device. And each device have a special ID number.
3.
GSM modem program mode (GSM modem program adapter)
Check the select box of the “ use modem”
For this mode,that is to use the SMS to program the remote GSM-KEY device. So you need to
input the “ Receive expired time ”, and also need to input the GSM-KEY device SIM card
number into the “ unit phone number ” text box.
For this mode, you also need to put another SIM card number in the GSM Modem
Normally the “ Receive expired time ” is setup to 2 minutes ( 120 seconds ),
The “ unit phone number ” is the SIM card number in the remote GSM-KEY device,not the
SIM card number in the GSM Modem.