WAFER GSM-KEY-DC REMOTE CONTROL UNIT
http://www.waferstar.com
Acknowledge
: UDI1:XXXXXX, DI2:XXXXXX OKAY
(When the Alarm input is triggered,then will send the
SMS you already setted with this UDI command)
#CSQ Check GSM signal quality
.
This command is useful to see what is the GSM network
signal level your GSM-KEY is receiving. It ranges from 0 to 32 (if it is 0 we doubt it will
ever answer...). You should have a signal above 12 to be sure of being able to open the
gate in any condition. Better if above 16. You should add an external antenna if this is not the case,
or eventually even change operator with another that serves your area better.
#PWD123456#CSQ?
Acknowledge:
CSQ IS 26
#MODE Relay Operation Mode SETUP
#PWD123456#MODE0
Acknowledge
: RELAY SET TO MODE0
#PWD123456#MODE1
Acknowledge
: RELAY SET TO MODE1
If set to MODE0,that is
Momentary pulse and If Config to MODE1,that is Ratchet relay
#STATUS Check the config information of the terminal
#PWD123456#STATUS?
You will receive a Acknowledge with:
ALARM1=ON:SMS:10,ALARM2=ON:SMS:20,GOT=1000,WHL=85,ALARM1=H,ALARM2=
H,BCPW=34,CSQ=20,RELAY=ON
#PWD123456#TIMER-UPDATE: 96754667
This is used to setup the phone number that is used to update the device inside working clock
You will receive a Acknowledge with:
#PWD123456#TIMER-UPDATE: 96754667 OK
#PWD123456#CLOCK ( Only the Timer update phone number can be effective with this )
That is used to update the device clock with the specified update phone number
Acknowledge
: CLOCK UPDATE TO 2010-10-18,16:58:10
#PWD123456#OUT1=ON
This is used to control the outpt switch to ON
Your will receive the Acknowledge as
:
OUT1 ON okay
#PWD123456#OUT1=OFF
This is used to control the outpt switch to OFF
Your will receive the Acknowledge as
:
OUT1 OFF okay
PC Software interface:
Software language select
Select the right language according to your county,wafer will update the language step by setp.
(When Distributor need to support your local language,please contact wafer company)
