WAFER GSM-KEY-DC REMOTE CONTROL UNIT
http://www.waferstar.com
Miscellanelous Parameters Setting Page:
Unit Info:
That is showing the Device edition of the design,you don’t need to change it
Unit Time;
That is used to setting the timer of the GSM-KEY Device
Unit Password:
That is used to change the control password
Reception:
That is used to test the GSM signal quality of the site
Battery backup:
That is used to setup the Power off alarm when power off.
Self clock update SMS: That is used to setup the phone number that is used to update the clock
Band selection:
Not available
Relay Mode:
That is used to setup the working mode
Relay Status:
That is used to test the device through ON or OFF the on board relay
Alarm:
That is used to setup the alarm mode of the two alarm channel
Alarm content:
That is used to setup the alarm SMS content.
Note:
1.
Gate delay cann’t be setup to “0”, then when you call the device, that relay output would not
work.
2.
You should not change the BAND selection if you are not very familiar with the GSM device,
that would cause the function to stop to work
3.
You can use the Relay Status selection box to check if that relay output can work well or not.
4.
Battery backup function is not available on the normal Wafer products.
