Waeco PerfectView M9LQ, Installation And Operating Manual

Page: 27 / 276

PerfectView M9LQ Safety and installation instructions
EN 27
If you disconnect the negative terminal of the battery, all data stored in the volatile
memories will be lost.
 The following data must be reset, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the operating manual.
Observe the following installation instructions:
!
Observe the following instructions when working with electrical parts:
 When testing the voltage in electrical cables, only use a diode test lamp (fig. 1 1,
page 3) or a voltmeter (fig. 1 2, page 3).
Test lamps with a bulb (fig. 1 3, page 3) consume excessive current which can
damage the vehicle's electronic system.
 When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig.
3 , page 4).
 Insulate all connections.
 Secure the cables against mechanical wear by using cable binders or insulating tape,
for example on existing cables.
Observe the following instructions when handling the LCD monitor:
!
CAUTION!
 Secure the monitor in such a way that it cannot become loose under any
circumstances (sudden braking, accidents) and cause
injuries to the
occupants of the vehicle.
 Do not attach the monitor in the air bag deployment path, as this could cause
injury if the airbags are triggered.
CAUTION!

People (including children) whose physical, sensory or mental capacities or
lack of experience or knowledge prevent them from using this product safely
should not use it without the supervision or instruction of a responsible
person.
 Do not open the monitor (fig. 4 , page 4).

Do not immerse the monitor in water (fig.
5
, page 4); the monitor is not
waterproof.
 The monitor must not impair your vision when driving (fig. 8 , page 5).

Do not operate the monitor with wet hands.

Do not operate the monitor if the housing has been damaged.