SinePower
Fastening the inverter
43
“Power Status” LED (fig.
2
2, page 4)
The “Power Status” LED shows the operating status of the inverter.
8
Fastening the inverter
You can fasten the inverter using the holders supplied.
When selecting the installation location, observe the following instructions:
z
The inverter can be mounted horizontally or vertically.
z
The inverter must be installed in a place that is protected from moisture.
z
The inverter may not be installed in the presence of flammable materials.
z
The inverter may not be installed in a dusty environment.
z
The place of installation must be well-ventilated. A ventilation system
must be present for installations in small, closed spaces. The minimum
clearance around the inverter must be at least 25 cm.
z
The air intake on the underside or the air outlet on the back side of the
inverter must remain clear.
z
For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the inverter under load
can lead to the automatic shut-off of the inverter.
z
The installation surface must be level and sufficiently strong.
You must be able to support the weight of the inverter.
z
Make sure you have adequate space for the cable connections under-
neath the device when choosing a mounting location.
I
Note
With the cable socket, you can secure the connection cable to the
back side of the device. After running the cable, secure it with cable
ties to the clips on the cable socket.
Display
Input voltage
Orange, constantly lit
Normal operation with battery power supply
Orange, slowly flashing
Energy-saving mode
Green, constantly lit
external supply via 230 V
AC
voltage
Red, quickly flashing
Input voltage too high
Red, slowly flashing
Input voltage too low
Red, occasionally flashing
Overheating
Red, constantly lit
Excessive load
_MSP702_MSP2524.book Seite 43 Montag, 23. Mai 2011 4:53 16
