Wacom DTI-520UB, User Manual

Page: 26 / 31

25
Message What to Do Reference
Prior to connecting the product, if you have a monitor
that you have been using, connect it and then adjust
the horizontal frequency to 30–80 kHz and the vertical
frequency to 50 –75 Hz. Connect the product.
-
- Verify that the video signal cable* is connected.
- Verify that the video signal cable connector pins are not
bent or broken.
• When the computer goes in to power saving mode,
move the mouse or press any keyboard key.
• Verify that the computer graphics board is correctly
installed.
P.11
-
-
-
• Verify that the video signal cable is connected.
• Verify that the video signal cable connector pins are not
bent or broken.
• If you are using a cable other than the video signal cable
that was included with the product, this message may
appear prior to the computer going into power-saving
mode. The product is not out of order. Use the cable that
was included to connect the product.
P.11
-
P.9
The RGB – RGB cable is not connected. P.11
The composite video cable is not connected. P.11
Set the refresh rate so that it is 70Hz or less.
The refresh rate may be adjusted at the Screen Profile
dialog box for your computer.
-
Display Troubleshooting
If One of These Messages Should Appear...
Troubleshooting
Caution:
* Video signal cable indicates both USB cables (see page 9).
If One of These Conditions Should Appear...
Condition What to Do Reference
The power lamp lights up orange or
orange and blue.
• Verify that the video signal cable is connected.
• Verify that the video signal cable connector pins are not
bent or broken.
• When the computer goes in to power saving mode,
move the mouse or press any keyboard key.
• Verify that the computer graphics board is correctly
installed.
P.11
-
-
-
The power lamp doesn’t light up
and the screen doesn’t display.
• Verify that the power cable is connected and turn the
power switch on.
P.10-11
- The screen doesn’t display even
when the power switch is turned on.
UM-0325(B)_EN.indd 25 09.8.31 6:06:48 PM