wc_tx004430gb_FM10.fm
41
LTV
Machine Setup
4.6
Aiming the Lights—Vertical Mast Light Towers
Overview
■
Each individual light fixture can be independently aimed up, down, left, or right.
There are four total light fixtures on each machine.
■
This procedure is not for rotating the lights as a single unit while the tower is
raised. This procedure requires the tower is lowered and the machine is
stopped. To rotate the lights, see topic
Rotating the Lights
.
Requirements
Before adjusting the lights, make sure that the following conditions have been met.
■
Machine is stopped
■
Tower is completely lowered
■
Lights are cool to the touch
Aiming the
light fixtures
Aiming Up or Down
Perform the procedure below to aim an individual light fixture up or down.
1. Loosen the T-handle
(a)
and aim the light up or down.
NOTICE:
Do not loosen the nut
(b)
. Damage to the light fixture may occur.
2. Tighten the T-handle
(a)
when the light is aimed properly.
3. Repeat steps 1–3 for each remaining light fixture, if desired.
This procedure continues on the next page.
wc_gr013746
a
a
a
b
Summary of Contents for LTV6K
Page 8: ...Table of Contents LTV wc_bo5100030216_02_FM10TOC fm 8...
Page 21: ...wc_si001039gb_FM10 fm 21 LTV Labels wc_gr013743 W W V T U Q S...
Page 108: ......
Page 110: ......
