wc_tx003206gb.fm
29
HDR 155
Operation
Continued from the previous page.
Requirements
Position the machine:
So that burner exhaust will not enter nearby structures.
So that the machine does not block traffic.
So that the machine is not close to any combustibles or flammable vapor.
So that the machine is not exposed to high levels of dust or airborne debris.
So that all of the machine’s access doors/panels may be accessed.
So that the cord does not pose a tripping hazard, and so the cord cannot be
damaged by machines or other equipment on the job site.
So that the machine is not sitting in pooled water or deep snow.
Machine must be on flat, firm surface.
Guidelines
Observe the following guidelines when positioning the machine for operation.
Installer must be familiar with all applicable laws, codes, regulations, or other
restrictions regarding installation of direct-fired radiant heaters.
Install wedge blocks under the wheels to prevent movement.
Installation must adhere to proximity restrictions.
Tip-over
protection
This machine features tip-over protection. Operation is disabled if the machine tips
past thirty five degrees from the horizontal. Return the machine to a horizontal
position to resume operation.
Proximity
restrictions
The machine must be located a safe distance from any other structures, vehicles,
materials or other combustible surfaces. The following proximity restrictions apply
for all machine installations.
30" (0.76 m) from side and rear (air inlet) of heater
80" (2.03 m) from surfaces above heater
40" (1.02 m) from air outlet of heater
20' (6 m) from outlet to external fuel container
