Wacker Neuson DPU 5545He, Operator'S Manual

Page: 29 / 48

Operation
T00996GB.fm
29
3. Turn ignition switch key (22) to operating position; then push in
starter button and hold until engine is running.
Wait until the engine stops before repeating the starting procedure.
4. Turn throttle control lever (8) into idling position, allow engine to
warm up for 7 minutes at idling speed.
Note: Do not activate automatic decompression lever while the engine is
running.
NOTICE
Improper use can damage the compression lever.
If the engine does not start, proceed as follows before attempting to start
again:
1. Press the compression lever down fully and then pull it up.
2. Start the engine again.
4.2 Forward and reverse motion
The engine speed can be infinitely varied on the throttle control lever.
The direction of travel is determinet with the shift lever (6).
Depending on the position of the shift lever (6), the vibration plate
compacts in forward direction, at standstill or in reverse direction.
The forward and reverse speeds can be varied by selecting
intermediate positions of the shift lever (6) or the machine can be
employed for particularly intensive compaction at standstill.
Standsill
Reverse
Forwards