10 Troubleshooting
100_0202_ts_0008.fm
55
10 Troubleshooting
10.1
Fault table
DANGER
Danger to life through unauthorised troubleshooting.
If faults arise with this machine that are not described in this manual, contact
the manufacturer. Do not arbitrarily fix faults.
Fault
Possible causes
Remedial measure
Reverse travel speed too low.
Insufficient hydraulic oil in the
centre pole head.
Fill with hydraulic oil.
Forward speed too low.
Too much hydraulic oil in the
centre pole head.
Correct oil level accordingly.*
Air in the hydraulic control sys-
tem.
Bleed.*
Not moving forward.
Mechanical fault.
Have the machine repaired.*
*This work is to be performed by the Wacker Neuson contact partner's service.
Loss of hydraulic oil.
Leaks
Have the machine repaired.*
Engine will not start.
Defective ignition lock.
Have the machine repaired.*
Defective starter motor.
Discharge starter battery.
Charge starter battery.
Low oil level.
Add oil and actuate valve lever
on the oil filter housing once.
Charge indicator light does not
go out.
Alternator failure.
Have the machine repaired.*
Switch cannot be silenced.
Regulator failure.
Compaction display (optional):
If all LEDs are permanently
flashing after initialisation, the
sensor has not been success-
fully tested.
Switch-on procedure when en-
gine is running.
Have the machine repaired.*
Sensor failure.