3 Security
11
100_0202_si_0008.fm
Before starting work, check the engine to ensure there are no leaks and/or cracks in the fuel lines,
tank, and fuel cap.
Do not operate a defective engine. Replace damaged parts immediately.
The pre-set engine speed may not be adjusted. This could lead to engine damage.
Make sure that the exhaust system of the engine is free of debris. Fire hazard!
Switch off before refueling the engine.
Use the correct type of fuel. Fuel should not be mixed with any other fluids.
Use clean filling aids when refueling. Do not spill fuel. Wipe up any spilled fuel immediately.
The engine must not be started in the vicinity of spilled fuel. Risk of explosion!
When operating in partially enclosed spaces, adequate ventilation must be ensured. Do not inhale
exhaust fumes. Risk of poisoning!
The engine surface and exhaust system can quickly become extremely hot. Risk of burns!
Do not open the radiator cap when the engine is hot – Beware of hot coolant!
3.10
General safety instructions – fuel, lubricants and coolants
The following instructions must be complied with:
Always wear safety glasses and protective gloves when handling fuel, lubricants and coolants. If
hydraulic oil, fuel, oil, or coolant gets into your eyes, consult a physician immediately.
Avoid direct skin contact with fuel, lubricants and coolants. Immediately rinse skin with soap and
water.
Do not eat or drink while working with fuel, lubricants and coolants.
Hydraulic oil or fuel contaminated by dirt or water can cause premature wear or failure of the machine.
Dispose of replaced or spilled fuel, lubricants and coolants in accordance with the applicable
provisions for environmental protection.
If fuel, lubricants and coolants escape from the machine, immediately cease operation and have it
repaired by your Wacker Neuson contact partner.
3.11
General safety instructions – starter batteries
The following instructions must be complied with:
When disconnecting the starter battery, always disconnect the negative terminal first!
When connecting the starter battery, always connect the positive terminal first! Fasten battery
terminal cover!
Flames, sparks, and smoking are prohibited when handling starter batteries.
Starter batteries contain corrosive acid. Wear acid-proof protective gloves and safety glasses when
handling starter batteries.
Prevent incorrect connection of the starter battery or bridging of the terminals with tools. Risk of short
circuit!
3.12
Maintenance
The following instructions must be complied with:
This machine may not be maintained, repaired, set, or cleaned while it is switched on. When working
on the electrical system – Disconnect starter battery!
Comply with maintenance intervals.
After any maintenance or repair, the safety devices on this machine must be replaced.
Note maintenance schedule. Any work not performed must be undertaken by the service of the
Wacker Neuson contact person.
Worn or damaged machine parts must always be replaced immediately. Only use spare parts from
Wacker Neuson.
Keep the machine clean.
NOTE
This machine is outfitted with an EPA-certified engine.
Changing revolutions per minute (RPM) influence the EPA certification and the emissions.
Settings for this engine may only be changed by a professional.
For more information, contact the manufacturer or your Wacker Neuson contact person.
