Chapter 7, Service and Repair
E.H. Wachs
Part No. 16-MAN-01, Rev. 4-1109
59
Chapter 7
Service and Repair
SDB 103 S
ERVICE
Use the following procedures for service and repair of the
SDB 103 machine components.
Replacing the Front Bushing
Replace the front bushing (16-030-00) if it shows wear or
damage.
1.
Remove the mandrel from the machine.
2.
Remove the 4 screws holding the tool head and
remove the head from the machine.
3.
Insert a 1.25” diameter drift pin from the rear of the
main shaft and use it drive out the old bushing.
4.
Place the new bushing on a bushing driver (part # 16-
033-00 available from E.H. Wachs), and press it into
the main shaft until the edge of the bushing is flush
with the front of the shaft.
5.
Replace the tool head and the mandrel.
FF 206 S
ERVICE
Use the following procedures for service and repair of the
components specific to the FF 206 flange facer.
In This Chapter