SDB-103 Small Diameter Beveler and FF 206 Flange Facer
34
Part No. 16-MAN-01, Rev. 4-1109
E.H. Wachs
4.
Push the mandrel into the pipe so that the squaring
plate is pressed tight against the pipe face. Tighten the
drawbar nut while holding the mandrel in this posi-
tion.
5.
Loosen the set screws in the squaring plate and
remove the plate from the mandrel. Check the location
of the legs in the pipe.
Figure 5-15. The mandrel legs should be close to the
edge of the pipe.
6.
If you need to install the SDB 103 or FF 206 on the
mandrel, slide the tool head over the mandrel and
position the machine to line up the keys and the key-
way slots. Turn the feed handle clockwise to thread
the mandrel into the machine.
Installing and Centering on Elbows and Bends
1.
When inserting the mandrel into the pipe, position the
adjustable leg at the “short radius bend” side of the
pipe. Make sure the screw on the adjustable leg is
screwed all the way in.