Chapter 5, Operating Instructions: Setting Up the SDB 103
E.H. Wachs
Part No. 16-MAN-01, Rev. 4-1109
29
The independent fitting mandrel is not self-squaring. You
will need to use the squaring plate provided with it to square
the machine to the pipe face.
1.
If necessary, remove the standard mandrel from the
SDB 103.
2.
Insert the independent fitting mandrel through the tool
head until it stops. Position the mandrel so that the
keyways are aligned with the keys in the machine, and
turn the feed handle clockwise to thread the mandrel
into the feed nut.
3.
Measure the pipe I.D., and select the extension leg set
required. Refer to the extension leg chart in Table 3
below.
4.
Insert the legs into the mandrel head. The adjustment
screw in the adjustable leg must be completely
screwed in.
Table 3: Independent Fitting Mandrel Extension Legs
Part Number
(Solid/
adjustable)
Length
(Solid/
Adjustable)
Min. Diameter
Max. Diameter
16-053-01
N/A
.0794” (20.1 mm)
N/A
1.95”
(49.5 mm)
2.31”
(58.6 mm)
16-053-02/
16-054-02
.944” (23.9 mm)
.824” (20.9 mm)
2.25”
(57.1 mm)
2.61”
(66.2 mm)
16-053-03/
16-054-03
1.094” (27.7 mm)
.974” (24.7 mm)
2.55”
(64.7 mm
2.91”
(73.9 mm)
16-053-04/
16-054-04
1.244” (31.5 mm)
1.124” (28.5 mm)
2.85”
(72.3 mm)
3.21”
(81.5 mm)
16-053-05/
16-054-05
1.394” (35.4 mm)
1.274” (32.3 mm)
3.15”
(80.0 mm)
3.51”
(89.1 mm)
16-053-06/
16-054-06
1.544” (39.2 mm)
1.424” (66.1 mm)
3.45”
(87.6 mm)
3.81”
(96.7 mm)
16-053-07/
16-054-07
1.694” (43.0 mm)
1.574” (39.9 mm)
3.75”
(95.2 mm)
4.11”
(104.3 mm)
