Chapter 3, Introduction to the Equipment: SDB 103 Small Diameter Beveler
E.H. Wachs
Part No. 16-MAN-01, Rev. 4-1109
11
Figure 3-3. The SDB standard tooling allows the
operator to face, bevel, J-prep, and counterbore pipe
and tube.
Optional Mandrels
A
small-diameter conversion kit
(16-401-00) with a
smaller mandrel and tool head is available. The conversion
kit allows you to install the machine on pipe I.D.s from
0.875” to 1.75” (22.2-31.8 mm).
Collet-style mandrels are also
available for pipe or tube. Call
E.H. Wachs customer service
to discuss your application’s
requirements.
The standard and small I.D. mandrels automatically center
the machine on the I.D. and squares it to the centerline of
the pipe. If you need to mount the machine in a pipe that is
on a bend or that has limited I.D. access, an
independent
fitting mandrel
(16-414-00) with dowel-style clamp legs is
available as an option.
With the independent fitting mandrel, you can adjust the
machine to be squared to the pipe end surface, rather than
the centerline. (This mandrel can also be used to mount the
FF 206.) A squaring plate for aligning the machine during
installation is provided with the mandrel.
Facing tool
26-410-02
10° Deburring tool
26-412-02
37.5° Beveling tool
26-411-01
Counterbore/
facing tool
26-426-00
NOTE
