Chapter 5, Operating Instructions: Setting Up the SDB 103
E.H. Wachs
Part No. 16-MAN-01, Rev. 4-1109
27
Figure 5-6. Each leg set is stamped with a reference
number which corresponds to the pipe I.D. range the
leg set will accommodate.
2.
Select the required extension leg set. The extension
legs each have two captivated screws used to fasten
them to the mandrel legs.
3.
Tighten the captivated screws on the extension legs to
attach the extension legs to the mandrel legs.
Figure 5-7. Attach the clamp legs to the mandrel and
tighten the 2 screws in each leg.
Installing the Small I.D. Conversion Kit
The small I.D. conversion kit (part number 16-401-00)
allows you to install the SDB 103 on pipe I.D.s down to
0.875” (22.2 mm). The kit includes a thinner mandrel and a
tool head with a smaller bore. Use the following procedure
to replace the standard mandrel and tool head.
