152
20. Mounting bracket (optional)
The mounting bracket is used to accommodate drive units with a 23 mm diameter Euronorm collar. This
enables the use of devices, such as drills, routers and high-frequency spindles on a WABECO milling
machines.
Like the standard milling head, the mounting bracket can be swiveled by 90 degrees to the left or the
right.
(see chapter: “Swivel milling head”)
20.1 Mounting the mounting bracket to the milling machine
For machines that are fitted with the mounting bracket at the factory, mounting will not be required.
Attention should be paid to ensure that the index bolt, unlike the standard milling head, is attached to the
right side of the mounting bracket.
If the mounting bracket is to be subsequently fitted to the machine, this will by default replace the milling
head mounted on the milling machine.
To mount the mounting bracket, first remove the index bolt as described in chapter: “
Swivel milling
head
”. Then fully unscrew the hexagonal screw (2) and hexagonal nut (3). The milling head can then be
removed carefully and replaced by the mounting bracket.
To secure the mounting bracket, fit and screw the hexagonal screw (2) and hexagonal nut (3) back into
place far enough that the mounting bracket can still be swiveled.
Then align the mounting bracket and tighten the hexagonal screw (2) and hexagonal nut (3) fully.
The index bolt for quickly aligning the milling head/mounting bracket may continue to be used. The cone
boring necessary for this must be made by the client in the mounting bracket or vertical slide. For this
reason, the mounting bracket has a pilot drilled hole on the right side.
1
2
3
4
Summary of Contents for F1410 LF
Page 41: ...41 7 Fitting and removing the tools 42 6 Spannen und Ausdrücken der Werkzeuge 1 2 3 4 5 ...
Page 98: ...98 16 Drawings and legends 16 12 Spindle Z axis with ball screws 16 12 1 F1410 LF F1410 LF hs ...
Page 126: ...126 16 Drawings and legends 16 22 Support arm for control panel 1 2 3 4 5 6 8 9 5 4 7 9 8 ...
