46
11. Adjustment of the spindle nuts with trapezoidal thread spindle
The spindle nuts of the milling machines are designed to be adjusted.
If a spindle nut of one of the three axis shows play, proceed as follows.
With spindle nuts with a ball screws, adjustment is neither required nor possible
11.1 X-axis
1. To adjust the spindle nut in the X-axis (2) the cross slide support is moved to the middle.
2. After undoing the threaded pin (1), the adjustment nut (3) is rotated slightly in a clockwise direction.
This rotation causes both nuts to tension each other and removes the play from the operation of the
trapezoidal thread spindle. .
3. After the setting has been made, tighten the threaded pin (1) back up again.
1
2
3
Summary of Contents for F1410 LF
Page 41: ...41 7 Fitting and removing the tools 42 6 Spannen und Ausdrücken der Werkzeuge 1 2 3 4 5 ...
Page 98: ...98 16 Drawings and legends 16 12 Spindle Z axis with ball screws 16 12 1 F1410 LF F1410 LF hs ...
Page 126: ...126 16 Drawings and legends 16 22 Support arm for control panel 1 2 3 4 5 6 8 9 5 4 7 9 8 ...
