41
6. Machine support order no. 24460
6.1 Assembly
The machine support is used to hold a second drive unit in the drill stand/milling stand.
Due to the international toothing of the machine support it is possible to rotate it in 15° steps around the hexagon steel
arm (11) of the drill stand/milling stand.
1. Position the neck of the hand-held drilling machine in the machine support (9) and align the drive unit
2. Tighten the clamping screw (9.1) by means of an Allen key
3. Loosen the clamping screw (9.3) of the base plate (9) by means of an Allen key
4. Install the machine support (9) at the desired angle to the extension-steel rail (11) of the drill stand/miiling stand.
5. Re-tighten the clamping screw (9.3) of the machine support (9)
6.2 Drawing and legend
Part no.
Pieces
Order no.
Designation
9
1
51006831-0010
Machine support
9.1
1
16191200008035
Clemping screw
9.2
1
16198500008000
Nut
9.3
2
16191200008025
Clemping screw
9.4
2
16198500008000
Nut
7. Clemping fixture order no. 22312
7.1 Assembly
The clemping fixture is installed into the machine support of the drilling stand respectively drilling stand/milling stand.
1.
Install the span neck of the drive unit into the clemping fixture (1).
2. Tighten the clamping screw (2) by means of an Allen key.
3. Release the clamping screw (9.1) of the respective machine support (9) with an Allen key.
4.
Push the clamping fixture into the machine support (9) until the collar of the clemping fixture touches the machine
support.
5. Adjust the drive unit
6. Re-thighten the clemping screw (9.1) of the machine support (9)
7.2 Drawing and legend
Part no.
Pieces
Order no.
Designation
1
1
51006831-0016
Spannvorrichtung
2
1
16191200008030
Klemmschraube
3
1
16193400008000
Mutter
