TEBS E
8
Installation notes
for vehicle installation and retrofitting
151
Vehicle with mechanical suspension
– Move the height sensor to the middle of the main axle. Make sure that structural
movement does not ‘knock over’ or break the sensor.
Always use the bore hole 100 mm from the height sensor turning shaft.
The black lever on the height sensor is not to be extended because the load in-
formation would become imprecise and represent an incorrect braking pressure.
The lever on the height sensor must be directly connected to the rubber link of
lever 441 901 71. 2.
The lever is supplied complete, including two rubber links and connecting rod in
various lengths.
The connection to the axle is made with an angle iron welded to the axle.
For vehicles with two height sensors, the rear axle left height sensor must be
connected to the axle c-d sensed by ABS, and the front axle right height sensor
to axle e-f sensed by ABS.
WARNING
Malfunctions with TEBS E
– Installing the wrong height sensors can cause malfunctions with TEBS E.
The height sensor should not be installed on tag or lifting axles.