53
Start-up
"Warning lamp configuration" tab
–
Configure possible warning lamps.
For a towing vehicle ECU, only one external warning lamp can be
configured.
For a trailer ECU, two external warning lamp can currently be configured.
8.2.4
Country-specific adjustments
–
In the Diagnostic Software, carry out country-specific adjustments, e.g.
indication of bar or PSI, use of USA radio protocol (FCC), resolution of the
tire message.
8.2.5
Expert parameters
!
As the last parameter setting define the parameters in the
Expert parameters
window.
Expert parameters are available for special applications:
–
In the
Parameter
under the module configuration tab activate the
Display
expert parameters
function for this purpose.
Ö
The
Expert parameters
window appears.
You have the following options:
Temperature warning:
If internal sensors are used, a warning message can be given out when the
defined temperature value is exceeded. 100 °C is defined as default here
(maximum value: 120 °C).
Tire status messages:
Here the transmission of trailer data in the towing vehicle and the
transmission of the vehicle configuration can be deactivated. The latter can
be useful for telemetry configurations.
With external sensors, the temperature transmission can be deactivated.
Tire pressure limit values:
Here the nominal pressure values that can be defined in the module
configuration can be restricted.
Lifting axle positions:
To prevent the monitoring of non-moving wheels (which, in the worst
case, can result in a sensor not being received) with lifting axles, the
corresponding axles can be selected here.
CAN configuration:
Here the CAN bus baud rate can be adjusted.
!
After the data is written to the ECU, diagnosis needs to be re-established.
CAN termination:
For an integration in an existing CAN bus or a trailer train configuration it
may be necessary to deactivate the CAN termination, which is activated by
default.
In addition, you can define whether the CAN termination should remain
activated in sleep and listen mode.
!
Increased power consumption with ignition off if the CAN termination is
activated with sleep and listen mode.
Summary of Contents for OptiTire
