WABCO OptiTire, System Description

Page: 52 / 72

52
Start-up Start-up
The modules can be assigned by means of a free or sequential assignment.
For this purpose a diagnostic message is stimulated for the selected sensors
and the corresponding ID is inserted automatically at the selected position:
– Under Module assignment, click the Execute button.
– Select
Sequential
(complete installation of a vehicle) or
Free module
selection
(replacement of a wheel or sensor).
8.2.3 Stimulating the sensors
Stimulating the external sensors
– From the READ OUT SENSOR menu on the WABCO OptiTire
TM
handheld
tool (WABCO part number: 300 200 001 0), select an external sensor (WM
2.2 TRIG or WM 2.4 TRIG).
– Hold the WABCO OptiTire
TM
handheld tool near the external sensor.
The adjacent wheel may interfere with the radio signal, in which case the
respective wheel must be turned.
Alternative
– For this purpose, touch the housing of each wheel module below the sticker
"OptiTire
TM
" for 5 seconds using a magnet (2 kg retention force) or using a
bar magnet parallel to the OptiTire
TM
logo.
External sensor with solenoid for simulating the external sensors
Stimulating the internal sensors
– Hold the WABCO OptiTire
TM
Handheld Tool (WABCO part number:
300 200 001 0) near the internal sensor, either from the tire flank side or
from the tread.
The adjacent wheel may interfere with the radio signal, in which case the
respective wheel must be turned.
WABCO OptiTire
TM
Handheld Tool for simulating the internal sensors
