W & H Lisa, Instructions For Use Manual

Page: 44 / 78

40
7.1.3 Cycle in-progress
While a cycle is in progress, the following parameters are displayed on the touch-screen:
•
Sterilization temperature and pressure – measured inside the chamber.
•
Elapsed time – time elapsed from the beginning of the sterilization cycle.
•
Residual time - time remaining until cycle completion.
•
Current cycle phase (e.g., PV1)
•
Cycle counter
•
Cycle name
In the central part of the screen, a simplified
cycle pressure profile is shown. As the cycle
proceeds, a progress bar overwrites the
completed cycle pressure profile, showing in
real time the actual phase the cycle is in.
If you press the "Info" icon, further technical
parameters are displayed. The "Info" icon
can be pressed at any time, also if there is no
cycle in progress; it provides important infor-
mation especially for service technicians.
7.1.4 End of cycle
Once the cycle is complete, the screen ap-
pears as in the image aside.
To unlock the door press the “Unlock door”
icon.
To view the parameters of the last cycle
press the “Info” icon before unlocking the
door.
NOTE:
If you do not open the chamber door at the end of the sterilization cycle (the sterilization load
remains in the chamber), the sterilizer vacuum pump is activated for a few seconds every 10
minutes for a time period of 40-60 minutes to keep the load dry.
NOTE:
If the “user authentication” option is activated, the user will be asked to identify
themselves before releasing the load.
If the password protection is activated as well, a password will be requested.
See §6.11 for further details.
The name of the user who released the load will be saved on the memory card and
printed on the cycle report.
ATTENTION! Load and trays will be hot at the end of the cycle!
Use tray or cassette holders to remove the load.
Info
Unlock door
Info
Cycle
pressure
profile
Progress
bar
Cycle
phase
Residual
time
Cycle counter
Manual stop
Elapsed
time
Cycle name