- 37 -
KEYB:LOC {OFF|ON}
This command sets button lock.
KEYB:LOC ON
locks all buttons from the device.
In order to unlock the device, you must press lock button and adjust the function.
KEYB:LOC OFF
unlocks all buttons from the device.
SYST:VERS?
This command checks the firmware version.
ex.) If the output result, when
SYST:VERS?
is entered, is equivalent to
“VUPOWER KS Ver.
1.0", it is shows the firmware version is 1.0.
SYST:ERR?
This command checks error messages that have occurred in chorological order.
ex.) The result can be anywhere from 0 to 16. Number means unchecked error messages. If
all of the messages are checked, you will see 0.
For more information please refer chapter 7.
Error Message.
○ REVISING COMMAND
[Warning]
Please turn off OVP and OCP function prior to correction.
All of revising devices must be able to read value wirelessly. To learn more
information on connecting devices refer chapter 4. Adjustment Please check off the
security firewall.
CAL:STAT {ON|OFF},<Password>
This function sets firewall on or off.
[Initial pin # is 1234]
CAL:STAT?
This checks status whether the function is allowed to make correction. Answer will come in
binary number. If the returning number is equal to
“0”, it means the firewall is set off and the
setting is allowed to make correction. If the returning number is equal to
“1”, it means the
firewall is set on and therefore you need to set off the firewall protection prior to correction.
CAL:VOLT:LEV {P1|P2},{MIN|MAX}
This command sets voltage parameter level.
e.g. If you enter
CAL:VOLT:LEV P1,MIN
, you will be able to read the lowest point of voltage
level.
6. Communication Interface Protocol
