SG-2SMT & SG-10SMT ADD-A-SECTION INST. (Continued)
9.
Bolt two closure panels (g) to upper back of unit
using four 5/16" hex head bolts and finish
attaching angled flue duct as shown in Detail P.
10.
While facing back of unit, remove two 51/6" hex
head bolts holding two stacking braces to the SMB
unit. See Detail N. Reinstall the bottom side
manifold cover using fourteen 5/16" hex head
bolts (See Detail Q) and reassemble stacking
straps to the SMB and SMT sections.
11.
Reinstall the SMT manifold cover using six 5/16" hex
head bolts (See Detail R)
12.
Tighten down all but the two back 5/16" hex head
screws of the new flue deflector resting on top of the
SMT unit (See Detail S).
13.
Assemble black hood stacking strip to back of SMT
unit using four 5/16" hex head screws. (See Detail T)
12