4.
Reverse procedure to install the replacement
switch and check for proper adjustment as
outlined in Door Switch under Service
Procedures and Adjustments.
HIGH LIMIT THERMOSTAT
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1.
Remove the top four racks from the oven.
2.
Remove the high limit thermostat cover/
mounting plate. It is located at the top of the oven
cavity.
Fig. 51
3.
Disconnect the lead wires from the high limit
thermostat. Remove the high limit thermostat
from the cover mounting plate.
Fig. 52
4.
Remove the old RTV silicone from the cover and
mating surfaces inside the oven cavity, and apply
new RTV silicone before installing.
5.
Reverse procedure to install.
COOLING FAN
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1.
Remove the right side panel as outlined under
Covers and Panels.
2.
Disconnect the lead wires to the fan motor by
removing the wire nuts.
3.
Remove the screws securing the air deflector to
the fan, then loosen the tab screw holding the fan
to the component panel. Rotate the tab so that
the fan will clear. Remove the fan.
SG4 & SG6 Series Full Size Gas Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
F35626 Rev. B (1118)
Page 24 of 56
