8
T
ONE
PULSE
REPEAT
ANSWER
MSG
STOP/PLAY
SKIP
ANSWER
MSG
MSG
SELECT
ON/OFF
RECORD/
MEMO
VOLUME
INT.COM
HOLD
MUTE
CONF.
LINE 1
LINE 2
OFF
MSG
L1
L2
POWER
CHARGING
SPARE BATTERY
ERASE
SELECT
TIME/SET
2
3
4
5
6
7
8
9
10
12
13
14
15
16
17
18
19
20
Figure 1
Figure 2
The Wall Mount bracket is designed to
fit on standard Wall Mount plates.
1. Choose a spot near an electrical
outlet and a telephone jack.
Your phone requires a modular tel-
ephone jack and a standard electri-
cal outlet (120v AC). The power cord
is six feet long; make sure there is
an electrical outlet within reach of the
Base. The outlet should not be con-
trolled by a wall switch. If the switch
is ever turned off, the phone will not
operate. (Unless you have a power
back-up battery)
2. Position the wall mounting
bracket on the Base.
Line up the tabs on the wall mount-
ing adaptor with the holes on the bot-
tom of the base (Figure 1). Snap
the wall mounting adaptor firmly in
place.
3. Mount the Base on the wall.
Position the Base so the mounting
studs will fit into the holes on the
bottom of the Base. Position the
power cord to extend down the wall
the phone is to be mounted on. Slide
the base down on the mounting
studs until it locks into place.
4. Connect the telephone cord.
The telephone line cord has a snap-
in plug at each end. Insert one of
the plugs into the jack on the back
of the Base. Insert the other end of
the plug into the wall jack.
5. Plug the AC adaptor into an elec-
trical outlet and the DC connecter
into the power jcak located on the
back of the Base Unit (Figure 2).
WALL MOUNTING
