VTech ErisTerminal VSP716A, Administrator And Provisioning Manual

Page: 72 / 204

Using the WebUI 72
Back to Contents
VSP716A Administrator and Provisioning Manual
On Hook The On Hook URI is triggered when the phone transitions
from Active to Idle (or from Paging to Idle). For example,
when:

The user presses the [End] soft key

The user hangs up the corded handset during a call

A transfer is completed and the user returns to idle

The far end hangs up

The call was not answered

The call fails.
Off Hook The Off Hook URI is triggered when the user goes to Dial
mode by:

Lifting the corded handset of the cradle

Pressing the SPEAKER or HEADSET hard key

Pressing a Line PFK

Pressing the [New] soft key during a held call.
Note that the Off Hook URI will NOT be triggered when
calling a pre-defined number and going immediately to
Dialling mode—this event triggers the Outgoing Call URI
instead.
Incoming Call The Incoming Call URI is triggered for each Incoming Ring
event or Call Waiting event. Using the Incoming Call URI, it is
possible to display extra information on the phone for an
Incoming Call. For example, the XML application that is
called when there is an Incoming Call can do a database
lookup and display information on the caller.
Note that this Action URI will not be triggered if DND or Call
Forward All is enabled or if Call Waiting is disabled (i.e., the
call is rejected).
Outgoing Call The Outgoing Call URI is triggered each time a SIP INVITE
message is sent (Dialling mode). For example, after:

Pressing the [Dial] key in Pre-Dial with populated
number

Using the dial pad to speed dial a call

Pressing a Quick Dial PFK

Dialling a Directory number by going off-hook.
Timer Based The Timer Based URI will be triggered when the configured
timeout expires. The timer starts at the end of the phone boot
sequence.
Timer Based Interval Enter the interveral before the Timer Based URI is triggered.
Setting Description