21
debugging is required.
4.1.7 Printer setup
The printer setup interface is as follows:
Figure 4
‑
12 Printer setup
Method of modifying: the transmission rate of printer is fixed to 9600. Click on
"Registration" column of the corresponding power to show "
√
". Press "OK" button to save the
setup and exit, otherwise press "Cancel" button to retain the original setup and exit.
Methods of replacing printing paper: press left button SEL to extinguish the indicator light,
open rear cover of the printer, press the right button LF to move the printer into paper skip state
and load into the printing paper. The shiny side of printing paper shall be upward for the thermal
printer.
"SPRT-02" system is set as thermal printer. The jumper hat on the
printer shall be removed or jump to one side. Its baud rate is set as 9600BPS.
4.1.8 System rename
The system name in the title bar can be changed by selecting the function. The interface is
as follows:
Figure 4
-
13 System rename interface
Apart from renaming, the system can set the number of the zone where it is located, and the
corresponding zone descriptive information. Click on "zone number" drop-down box to select the
zone number and 20 zones can be registered at most.
The example of changed name and zone descriptive information is as follows. The
changed name will be shown in the title bar.
Figure 4
-
14 System rename result
