VSpeak FLOW-meter 1.0, Manual

Page: 18 / 29

FLOW-meter Version: 1.0 www.VSpeak-modell.de
Page 18/29
2.3.4.2 FUEL
Here is the current FUEL display, according to the settings listed below
Settings
Value range
consumed / level
1, 5, 10, 20, 50, 100
OFF, PowerON
50 . . . 20000
GAM / ESC / VAR
Upon delivery, the warning thresholds are set as shown in the picture.

F-display
Here you can choose whether FUEL and FUEL% should display the increasing fuel
consumption (consumed) or the falling tank content (level).

F-rounded
The display accuracy of FUEL (ml) can be set here.
Rounding the display makes sense, when using speech to reduce the announcement syllables.

Autoreset
With Autoreset = Power ON, the consumption / tank display is reset to 0 ml
(F-display = consumed) or TankSize (F-display = level) each time the receiving system is
switched on.
With Autoreset = OFF the last value is stored and is available again after the receiver is
switched on again until a reset at the servo input (> 80%), or in the JetiBox, or in the
Textdisplay by pressing "SET".

Imp/Liter
Parameter for adapting the FLOW-meter electronics to the respective flow sensor (s. section
2.0.3 Calibration).

Sensor
In sensor the sensor type can be GAM, ESC or VAR. The change of the sensor type will
only take effect after restarting the FLOW-meter.