FLOW-meter Version: 1.0
Page 4/29
1
Hardware
Data LED: green (PN)
→
Calibration mode
green (flashing)
→
Data transfer tot he receiver
(at Jeti only then, if JetiBox buttons are activated)
red (flashing)
→
FUEL flows
The blue LED is blinking every second to signal the normal function of the Flow-meter.
The connection between the FLOW-meter and the remote control system is made
with the 3-pin servo patch cable except in the case of Spektrum, there with the special cable
(see following pictures):
The FLOW-meter can be connected to a servo port of the receiver using the 1-pin
servo patch cable – servo > 80% resets the FUEL value.
Button
Data LED
green/red
to the flow sensor
Micro SD card slot (bottom)
blue LED
3- pin servo patch cable
4- pin Spektrum XBus connection cable
(Please always indicate when ordering)
