Quality of service (WMM)
: enable to support quality of service for traffic prioritizing.
Client isolation
: select to enable the layer 2 isolation that blocks clients from
communicating with each other. Client isolations is available only in Access Point (auto WDS)
mode.
Enable DFS
: select to enable radar detection. With enabled DFS, 570n unit monitors the
operating frequency for radar signals. If radar signals are detected on the channel, the 570n unit
randomly selects a different channel.
Enable AMSDU
: enable the AMSDU packet aggregation. If enabled, the maximum size of the
802.11 MAC frames will be increased.
Mode
: choose the 570n antenna operating mode:
SISO
: single input single output. The device will use 1x1 antenna for data transfer. The
antenna will be chosen automatically.
MIMO
: multiple input multiple output. The device will use 2x2 antenna for data transfer
(two simultaneous streams).
Max data rate
: choose the maximum data rate in Mbps at which should transmit packets. The
570n will attempts to transmit data at the highest data rate set. If there will be an interference
encountered, the 570n will step down to the highest rate that allows data transmission.
Max data rate N
: choose the data rates in Mbps at which should transmit packets for the
selected 802.11n mode. The 570n will attempts to transmit data at the highest data rate set. If
there will be an interference encountered, the 570n will step down to the highest rate that
allows data transmission.
Disable data rate fallback
: when this option is selected, the constant Max data rate will be set
without a step back to the next highest data rate for 570n data transmission.
Short GI
: enable short guard interval. If selected, then 400ns value will be used, else 800ns.
MPDU density
: define minimum time between PPDU's.
ACK timeout
: specify the ACK timeout using slider or enter the value manually. Ack timeout can
be entered by defining the link distance or specifying time value. Too low value of the ACK
timeout will give very low throughput. A high value may slow down the link in noisy environment.
A low value is far worse than a value slightly too high. ACK Timeout value should be tuned to the
optimal value for the maximum link throughput.
Wireless Mode: Station
Station WDS has the same wireless settings.
