8
TIP
INSERTION (REPLACEMENT) OF THE BATTERY IN THE TRANSMITTER
Observe polarity when installing the battery. Reversing the battery
will damage the transmitter. Use only lithium CR2 3V batteries.
•
Remove the transmitter battery cover using a screwdriver.
•
If replacing the battery, remove the old battery and dispose
of it properly.
•
Place the lithium CR2 3V battery in the holder and press
into place.
•
Put the battery cover back into place and secure with screw.
The battery level is shown at the battery life status bar on the LCD display.
•
Battery fully charged: full battery icon is shown on the LCD display.
•
Low battery: battery empty icon is shown on the LCD display.
The stimulation is delivered through the receiver contact points. Two different series of contact points
are supplied. The length of the contact points must be sufficient to have proper contact with the dog‘s
skin, enabling the device to operate correctly. If you have a short-haired dog use the short 12 mm con-
tact points, if you have a long-haired dog replace them with the longer 17 mm contact points supplied
with the kit. Carefully tighten them manually (do not use a key or pliers). It is possible to purchase the
21 mm long contact points.
Choosing the contact points
You can easily lift up the battery using the small flat-head screwdriver.
Battery polarity
