10
Programming (coding) the transmitter with the receiver
Each transmitter has its own operational code. The programming of the transmitter with the receiver
enables the two units to work together. This operation will help you to program the receiver to work
with a new transmitter or to program a new receiver to work with your existing transmitter. Receiver can
be reprogrammed indefinitely, either with the same transmitter or a new VOSS.miniPET transmitter. It is
possible to program an unlimited number of receivers to one transmitter.
•
Switch on the transmitter.
The receiver must be switched OFF
.
•
Select dog 1 using the button on the transmitter.
•
Positon the lower part of the transmitter where the magnet is located against the white half circle
near the LED indicator on the receiver (see the picture on the page 9), hold for 5 second, the recei-
ver LED indicator will flash four times in green and red simultaneously indicating the receiver is in
programming mode.
•
Remove your transmitter and press the tone signal button on the transmitter. A beep sound is
emitted from the receiver on the collar; the receiver is then synchronized with the transmitter.
•
Select dog 2 using the button on the transmitter and proceed with the programming in the
same way as above (applicable when programming additional receiver for second dog, receiver
must be purchased separately).
IMPORTANT:
Before the programming make sure no other person is using his VOSS.miniPET
or other products from the VNT electronics range close by: your receiver could accidentally
record the code of his transmitter. In case of such an occurrence, simply repeat the
programming process.
