12
8) Assemble the Entrance Section (1) of the slide to the last Runway Section (2).
First, insert the hardware through the sides of the runway as shown in Figure 11,
Detail A. The
hardware required for this step is as follows: 3/8”-16 x 5” Button Head Cap Screw S/S (12), 3/8” Flat
Washer S/S (24), 3/8” Flat Washer S/S (24), 3/8” Lock Washer S/S (25), 3/8” Hex Nut S/S (26).
Next, attach the runway assembly to the last branch arm, as shown in Figure 11, Detail B. The bolts
will be threaded into the threaded inserts in the entrance section. The hardware required
includes: 3/8”-16 x 3.5” Button Head Cap Screw S/S (10), 3/8” Lock Washer S/S (24), 3/8” Flat
Washer S/S (25), and a 3/8” Nylon Washer (23).
Note: Be sure to apply anti-seize to all fasteners to prevent galling
After you have started all of these bolts, you should go back through and tighten all of the
fasteners installed up to this point .
Apply the .5” wide X .3” tall gasket to the top runway parts along the outside curve edge
only. The gasket should be applied on the mating surface, between the bolt holes and the inside
edge of the part.
JOINT B4
JOINT B5
JOINT B1
JOINT B2
JOINT B3
FIGURE 11
(12)
(24)
(25)
(26)
(10)
(24)
(25)
(23)
