14
VORTEX CLOSED FLUME ASSEMBLY INSTRUCTIONS
9) Assemble the four remaining Runway Section (2) pieces. Order of assembly is important.
The end of each runway section is labeled and must be assembled to the runway section with the
same number. Assemble two sections together that are labeled T1 on the mating ends. Fasten the
two sections together using the two bolt locations through the side of the parts as shown in Figure
12, Detail A. The hardware required for the two side locations is as follows: 3/8”-16 x 4” Button
Head Cap Screw S/S (11), 3/8” Flat Washer S/S (24), 3/8” Flat Washer S/S (24), 3/8” Lock Washer
S/S (25), 3/8” Hex Nut S/S (26). Next, finish fastening the parts together as shown in Figure 12,
Detail B. The hardware required for this step is as follows: 3/8”-16 x 5” Button Head Cap Screw (12)
and a 3/8” Flat Washer S/S (21), 3/8” Flat Washer (21), 3/8” Lock Washer (25), 3/8” Hex Nut (26).
Follow the same procedure to finish assembling the remaining two sections together. Assemble the
part labeled T2 to the previously assembled parts followed by the part labeled T3.
Note: Be sure to apply anti-seize to all fasteners to prevent galling
JOINT T1
JOINT T2
JOINT T3
(12)
(26)
FIGURE 12
(21)
(25)
(11)
(24)
(26)
(25)
