15
10) For this portion of the installation you will need 3-4 people. Slide all four pieces of the top portion
of the flume up the slide from the bottom. Make sure the gasket is in place. Next, attach the
hardware at the top of the runway as shown in Figure 13, Detail B. The hardware required for this
step is as follows: 3/8”-16 x 6” Button Head Cap Screw S/S (13), 3/8” Flat Washer S/S (24), 3/8”
Flat Washer S/S (24), 3/8” Lock Washer S/S (25), 3/8” Hex Nut S/S (26). Next, working from the top
to bottom, fasten the flumes together along the outside edge as shown in Figure 13, Detail A. The
required hardware is as follows: a 3/8”-16 x 5” Button Head Cap Screw S/S (12), 3/8” Flat Washer
S/S (24), 3/8” Flat Washer S/S (24), ½” Sch 40 PVC Spacer 3.25” (30), 3/8” Flat Washer S/S (24),
3/8” Lock Washer S/S (25), 3/8” Hex Nut S/S (26). Tighten the hardware until the gap in the joint is
closed.
Do not over tighten.
Note: Be sure to apply anti-seize to all fasteners to prevent galling
FIGURE 13
(12)
(24)
(25)
(26)
(24)
(13)
(26)
(25)
(24)
(30)
