31
2) First, place the Left Guard Rail (50) in the two sockets on the top of the Entrance
Section so that the bolt end comes through the body of the slide, as shown in Detail A.
Use the following hardware to attach the guardrail foot to the entrance section and the
ladder: 3/8” x 5” Button Head Cap Screw, 3/8” Flat Washer (24), 3/8” Nylon Washer
(23), 3/8” Nylon Washer (23), 3/8” Flat Washer (24), 3/8” Lock Washer (25), and a 3/8”
Hex Nut (26), see Detail B. Do not fully tighten yet. Then attach the hardware to the two
studs on the sides of the slide: 3/8” Flat Washer (24), 3/8” Lock Washer (25), and a 3/8”
Hex Nut (26), see Detail A. After all hardware has been attached tighten each bolt
securely.
Second, place the Right Guard Rail (51) in the opposite side and repeat the steps to
mount it securely to the slide.
Note: Be sure to apply anti-seize to all fasteners to prevent galling.
FIGURE 26
(24)
(12)
(24)
(23)
(25)
(26)
(25)
(26)
