VorTek Pro-T, Instruction Manual

Page: 69 / 150

Series M22/M23/M24 Instruction Manual Chapter 3 Operation
M-000-00010 3-9
Alarms Menu
Password
ENTER
Use
keys to access menus
Alarms
Menu
Relay Alarm 1
More >
ENTER
Run Mode
Relay Alarm 2
More >
Relay Alarm 3
More >
Alarm LOG
xx Files (ENTER)
Clear Alarm LOG?
YES or NO
<Measure> units
xxxx
xxxx
xxxx
Alarm File
Time
Date
(Press EXIT to return
to Alarm LOG)
* see below
Physical Layer does not exist on Two Wire
Mass - Accessible via HART
<Measure>
None
Mass
Volume
Temp 1,2
Press
Density
** Energy
<Measure>
None
Mass
Volume
Temp 1,2
Press
Density
** Energy
<Measure>
None
Mass
Volume
Temp 1,2
Press
Density
** Energy
<Mode>
None
HIGH Alarm (>)
LOW Alarm (<)
<Mode>
None
HIGH Alarm (>)
LOW Alarm (<)
<Mode>
None
HIGH Alarm (>)
LOW Alarm (<)
<Measure> units
<Measure> units
*
**
Energy EMS Meters Only
Example for Setting an Alarm
The following shows how to set Relay Alarm 1 to activate if the mass flow rate is greater than 100 lb/hr. You can
check the alarm configuration in the Run Mode by pressing the
 keys until Alarm [1] appears. The lower line
displays the mass flow rate at which the alarm activates. Note: all outputs are disabled while using the Setup Menus.
First, set the desired units of measurement:
1. Use  keys to move to the Units Menu (see to page 3-12).
2. Press  key until Mass Flow Unit appears. Press
ENTER
.
3. Press  key until lb appears in the numerator. Press  key to move the underline cursor to the
denominator. Press the  key until hr appears in the denominator. Press
ENTER
to select.
4. Press  key until Units Menu appears.
Second, set the alarm:
1. Use

keys to move to the Alarms Menu.
2. Press the  key until Relay Alarm 1 appears.
3. Press  key to access Measure selections. Press
ENTER
and use the  key to select Mass. Press
ENTER
.
4. Press  key to select the alarm Mode. Press
ENTER
and use  key to select HIGH Alarm. Press
ENTER
.
5. Press  key to select the value that must be exceeded before the alarm activates. Press
ENTER
and use
 keys to set 100 or 100.0. Press
ENTER
.
6. Press the
EXIT
key to save your changes. (Alarm changes are always permanently saved.)
(Up to three relay alarm outputs are available depending on meter configuration.)