VorTek Pro-T, Instruction Manual

Page: 12 / 150

Chapter 1 Introduction Series M22/M23 Instruction Manual
1-2 M-000-00010
Note and Safety Information
We use note, caution and warning statements throughout this book to
draw your attention to important information.
Warning!
Caution! Note
This statement appears with
information that is important to
protect people and equipment
from damage. Pay very close
attention to all warnings that
apply to your application. This statement appears with
information that is important
for protecting your equipment
and performance. Read and
follow all cautions that apply
to your application. This statement appears with
a short message to alert you
to an important detail.
Receipt of System Components
When receiving a VorTek mass flow meter, carefully check the outside
packing carton for damage incurred in shipment. If the carton is dam-
aged, notify the local carrier and submit a report to the factory or distrib-
utor. Remove the packing slip and check that all ordered components are
present. Make sure any spare parts or accessories are not discarded with
the packing material. Do not return any equipment to the factory without
first contacting VorTek Customer Service.
Technical Assistance
If you encounter a problem with your flow meter, review the configura-
tion information for each step of the installation, operation and set up pro-
cedures. Verify that your settings and adjustments are consistent with fac-
tory recommendations. Refer to Chapter 5, Troubleshooting, for specific
information and recommendations.
If the problem persists after following the troubleshooting procedures
outlined in Chapter 5, contact VorTek Instruments, Technical Support
Via Email at
Sales@vortekinst.com or by phone at (888) 386-7835 or
(303) 682-9999 between 8:00 a.m. and 5:00 p.m. MST. When calling
Technical Support, have the following information on hand:
•
the serial number and VorTek order number (all marked on
the meter nameplate)
•
the problem you are encountering and any corrective action
taken
•
application information (fluid, pressure, temperature and
piping configuration)