P/N: 4MB020-010
©2003 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
06DEC02 V1.0(4MB HP500 v1.0)
20
12. SUPERCHARGER MOUNTING, cont'd.
Fig. 12-g
Fig. 12-h
K. Carefully route the oil feed line up to the super-
charger oil feed fitting taking care not to kink or
cut the hose near any sharp edges. Carefully
thread the hose end onto the fitting while sup-
porting the fitting. LIGHTLY LUBRICATE FIT-
TING WITH ENGINE OIL.
L. Attach the supplied length of 1/2" x 24" breather
hose to the 90
°
barb on the supercharger air inlet
and the factory breather fitting.
J. Route the supplied supercharger belt onto the
crank and supercharger pulleys. Using a box-
end wrench on the tensioning wheel bolt, pull the
tensioner as far back as possible and carefully
slip the belt over the crank pulley. See Fig 12-g
for belt routing.
CAUTION:
Hold the supercharger oil feed fitting
with wrench while tightening the oil
feed line fitting.
CAUTION:
Ensure that the oil supply system is
free of contamination that might plug
the supercharger oil inlet orifice.
DESCRIPTION
10 Rib Belt
QTY.
1
PART #
2A041-618
NO.
1
WARNING:
1. Do not wrench excessively on the belt
tensioner wheel bolt or it may break
loose.
2. If idler pulley removal is required for
any reason, note that the idler pulley re-
taining screw has left hand threads.
Spacer
Ø1.00 x 1.536
SUPERCHARGER
MOUNTING
PLATE
IDLER SPACER #2
SUPPORT
PLATE
IDLER SPACER #1
FACTORY
IDLER
Fig. 12-f
