Group 30 Electrical System—VNL, VNM
Service Procedures
Installation
1
W3000999
1) Clock
2) Switch
Pull the switch electrical connector (2)
through the front of the panel. Install
the control panel by inserting the 3
tabs on the panel’s left side back into
the air vent trim panel and installing
the 2 torx bolts. Torque bolts to 1.5 ±
0.5 Nm (13 ± 5 in-lb).
Note: When replacing any switch in
this control panel, remove the
switch(es) in the right-most positions in
the rows of switches before installing
the panel. This allows better clearance
when installing the panel. Install the
switch(es) as described in this step.
1.5 ± 0.5 Nm
(13 ± 5 in-lb)
2
Install the switch back into the panel
by connecting the switch electrical
connector and pushing the switch into
the panel until it locks in place.
3
Gently pull on the switch to make cer-
tain it is locked in the panel.
3631-03-02-04
Windshield Wiper Motor Re-
placement
(Includes checking component function)
Removal
1
WARNING
Park the vehicle on a level surface, apply the parking
brakes, and block the wheels to avoid possible injury.
Failure to do so can result in personal injury and pos-
sible damage to the vehicle due to vehicle movement.
Make certain the vehicle ignition is
OFF before beginning this procedure.
2
W3000669
Disconnect the electrical connector
from the wiper motor.
3
Remove the nut from the linkage arm,
and push the arm from the shaft.
4
Push the linkage arm from the area
where the wiper motor is mounted to
the housing for access to bolts. Re-
move the 3 bolts to remove motor.
87
