EVC system display
IMPORTANT!.An.EVC.system.display.can.be.
connected.together.with.a.tachometer..The.dis-
play.can.also.substitute.a.tachometer..The.EVC-
C.system.must.have.either.a.tachometer.or.a.
display.
The following information is available in the
EVC-C system display:.
-.
Coolant.pressure
-.
Fuel.pressure
-.
Fuel.level
-.
Engine.oil.pressure
-.
Turbo.pressure
-.
Coolant.temperature
-.
Transmission.oil.pressure
-.
Voltage
-.
Exhaust.temperature
-.
Engine.oil.temperature
-.
Transmission.oil.temperature
-.
Engine.rpm
-.
Engine.running.hours
-.
Boat.speed
-.
Engine.Powertrim
-.
Sea.water.pressure
-.
Trip.data:.(fuel.rate,.fuel.consumption,.fuel.con-
sumption/time,.trip.fuel.consumption,.trip.fuel.
consumption/time,.remaining.fuel,.trip.hours,.trip.
distance,.remaining.distance.to.empty.tank,.re-
maining.time.until.tank.is.empty)
-.
Sea.water.depth
-.
Sea.water.depth.alarm
-.
Sea.water.temperature
-.
Rudder.angle
-.
Engine.oil.filter.differential.pressure
Information.is.depending.on.engine.model,.number.of.
sensors.and.type.of.accessories.
The.EVC.display.kit.consists.of.the.display.with.con-
nection.and.a.cable,.length.1.5.m.(5.ft).with.12-.and.
6-.pin.connections..An.extension.cable.may.be.used,.
lengths:.1.5,.3,.5,.7,.9,.11.m.(5,.10,.16,.23,.30,.36.ft)..
Please.refer.to.the.
Connection
section.on.the.next.
pages.
IMPORTANT!.Always.connect.instruments.and.
senders.which.are.common.for.both.engines,.
such.as.speedometer,.rudder.indicator.etc.to.
port HCU..The.port.engine.is.the.master.engine.
in.the.EVC.system.
NOTE!.In.a.twin.installation.the.default.setting.of.the.
display.will.show.port.engine.data..Please.refer.to.
the.
EVC system display/Calibration and settings
.
chapter.for.further.information.
IMPORTANT!.In.a.twin.installation,.when.using.
one.combined.EVC.system.display,.the.display.
must.be.configured.as.a.“
TWIN”.before.auto.con-
figuration.is.performed.
.
In.a.twin.installation,.when.using.two.EVC.sys-
tem.displays,.the.displays.must.be.configured.as.
“
PORT”.resp..“STARBOARD”.before.auto.con-
figuration.is.performed.
NOTE!.The.EVC-C.system.allows.maximum.one.dis-
play.connected.to.each.HCU.
Location and fitting
NOTE! Allow.adequate.clearance.behind.the.display.
for.cable.connection.to.ensure.that.the.cable.is.not.
unduly.stressed..Also.ensure.that.there.is.sufficient.
length.of.cable.to.remove.the.unit.for.servicing.pur-
poses.
The.instrument.is.usually.installed.on.a.dash.board..It.
can.be.mounted.from.above.or.flush.from.under.the.
dash.board..Flush.mounting.demands.tailor.made.
fittings..Templates.are.included..Please.refer.to.the.
Templates for controls and panels
chapter.
NOTE! Cut.out.dimensions.are.nominal.only.and.
should.be.checked.against.physical.units.prior.to.ma-
chining..
X5.MULTILINK.
Yellow
DISPLAY.
CONN.
Part.No.
63
EVC-C.
Installation.procedure,.helm
Summary of Contents for EVC EC -C
