Operation
42
VPA 7743722 English 10-2004
22786
22781
22784
22785
Power Tilt Operation
Tilting is normally used for raising the drive unit to ob-
tain clearance when beaching, launching from a trail-
er, or mooring. When tilting the drive unit, the boat
should be at rest or at idle speed only.
The trim/tilt switch controls the tilting feature of the
drive unit. When the trim/tilt switch is held in the “bow-
up” position, the drive unit tilts up until the switch is re-
leased or the drive unit reaches the maximum tilt po-
sition. The trim/tilt gauge will indicate the “tilt” position
whenever the drive unit is in the tilt range.
CAUTION!
Never exceed 1000 RPM when oper-
ating the drive unit in the tilted position (6°-29°)
because it may damage the drive system. Never
RUN the engine when the drive unit is tilted more
then 30° or the drive will be damaged.
Never operate the engine out of water or without water
supplied to the engine. The water pump may be dam-
aged or the engine may overheat. See flushing proce-
dures found in the maintenance section.
WARNING!
To avoid possible contact with the
propellers, never use the drive unit as a ladder or
as a lift to board the boat. Never board at the rear
of the boat when the engine is running, even if
the engine is operating in neutral. Personal injury
could result from contact with rotating engine
parts and propellers.
Any malfunction of the trim/tilt system could result in a
loss of impact protection. Malfunction can also result
in loss of reverse thrust capability. If malfunction oc-
curs, see your authorized Volvo Penta dealer.
Power Trim/Tilt Switch & Gauge Location
The power trim/tilt switch is located on the remote
control handle or on the boat’s dashboard. The trim in-
dicator displays the drive position in the Trim range.
With dual installations, it is permissible to individually
trim the drive in Trim range. When the drive is in
Beach range (7° to 10°), boat speed must be lower
than planing speed. The engine must be stopped
when fully tilted (Lift Range).
NOTE!
The automatic stop function between the
Trim range and Beach range is an optional
feature; unless you have the automatic stop
function installed on your boat, you should
check the trim indicator carefully during trim
operation.
7743722 - Downloaded from www.volvopenta.com 13/05/2008 20:17:06
