Operation
36
VPA 7743722 English 10-2004
21183-1
21181
Starting the Engine (Cold Start)
GL Models
A cold engine may require priming before you can
start it. To prime the engine:
1. Turn the ignition switch OFF (
0
).
2. Disengage the drive mechanism by pressing the
gear shift release button (
A
).
3. Depress the throttle lock and move the control
lever to FULL THROTTLE (
B
) in order to activate
the accelerator pump and prime the engine.
4. Return the remote control handle to a fast idle
position (about 1000 RPMs).
5. Turn the ignition switch to START (
II
) and hold it
there until the engine starts, but for no longer
than 10 seconds.
6. Once the engine starts, keep the throttle at a fast
idle (about 1000 RPMs) for 30 seconds before
returning to NEUTRAL.
7. Repeat priming if necessary.
CAUTION!
Too much priming may flood the en-
gine. If the engine fails to start after a few at-
tempts, there may be a problem that needs to be
addressed. See your authorized Volvo Penta
dealer for service.
Gi & GXi Models
1. Move the control handle to the NEUTRAL detent
position.
2. Turn the ignition switch to START (
II
) and hold,
for no longer than ten seconds or until engine
starts. If the engine does not start, let go
momentarily, then try again.
3. As soon as engine starts, release key to ON or
RUN (
I
).
If the Engine Floods
GL Models
1. Disengage the shift mechanism.
2. Move the remote control lever to FULL
THROTTLE (
B
).
3. Turn the key switch to START (
II
).
4. As soon as the engine starts:
•
Return the remote control handle to IDLE.
•
Turn the key to ON or RUN (
I
).
•
Move the remote control handle to FAST IDLE to
warm up the engine. Do not exceed 1000 RPM.
7743722 - Downloaded from www.volvopenta.com 13/05/2008 20:17:06
