60
7741591 / 2003-12
Preparing for boating after storage
(launching)
1.
Replace all drain plugs.
2.
Replace rubber caps and clamps or plugs.
3.
Connect hoses and check their condition; tighten clamps
and connections.
4.
Install boat drain plug, if removed.
5.
Remove and inspect distributor cap and rotor. Replace dis-
tributor with a new one, if necessary.
6.
Clean battery terminals and check battery charge.
7.
With ignition switch in
OFF position, install battery and at-
tach battery cables.
8.
Spray terminals with Volvo Penta anticorrosion spray.
9.
Open the fuel shut-off valve and check all fuel line connec-
tions for leaks.
10. Check the flame arrestor and clean if necessary.
11. Make a thorough check of boat and engine for loose or
missing nuts and screws.
12. Pump the bilge dry and air out engine compartment.
Fed-
eral, state, and/or local regulations prohibit the pump-
ing of oil into any navigable waters.
13. Check all reservoir oil levels and fill as necessary.
14. Check drive and transom shield anodes. Clean or replace
as necessary.
Off-season storage preparations
(“winterization”)
Be sure to properly winterize your Volvo Penta equipment. En-
gine or drive damage can result from ignoring simple preven-
tive maintenance steps during autumn. Winterizing gives you
the assurance that your engine will run more reliably and eco-
nomically in the springtime.
Volvo Penta recommends that you have your Volvo Penta
dealer “winterize” your engine and drive. Your dealer will pro-
vide the proper servicing and maintenance to ensure that your
equipment is treated and stored properly.
Exhaust System
Engine exhaust system
Periodically inspect the engine exhaust system. Check for:
•
Deteriorated hoses
•
Burned hoses
•
Loose clamps
•
Evidence of water leaks
•
Corrosion or blockage in the exhaust manifold and riser(s).
WARNING!
Replace damaged or defective components, and se-
curely tighten all clamps. Any exhaust leak must be
repaired before you operate you boat. Exhaust leaks
release fumes that can create hazardous conditions
for operator and passengers.
Drive unit bellows
WARNING!
If you work on the drive bellows, secure the drive
unit in a raised position in such a way that it cannot
fall. A falling drive may cause serious injury.
— Check the drive unit bellows for fractures and deteriora-
tion.
— Check tightness of all hose clamps
— Check the drive unit bellows and clamps every second year.
You may order the bellows separately, or as part of an
accessory kit. (The accessory kit also includes O-rings, oils,
washers, seals, and anodes.
— (DPX only) If hose clamps must be tightened, or hoses and
clamps must be replaced, the clamp screw positions must
be maintained as shown.
Maintenance
7741591 - Downloaded from www.volvopenta.com 12/03/2014 09:32:39
Summary of Contents for 3.0GL-B
