98-100 ISSUE 8
39
Figure 18
For example, if figure 18, the step size would be 0.1A.
Step 4: Set up the inductance measurement
Next, set up the inductance test voltage and frequency. Also, if the LCR meter is an
AT3600 or an ATi, you will need to specify the high and low node of the top matrix
between which the inductance measurement will be made. For the ATi, if you are
using an LCR fixture, then nodes 13 and 15 should be used.
Step 5: Run the test
Before you run the test, you need to decide whether you want to save the results to a
file. This can be done by checking the box under “Save Results” and then selecting a
destination location and file. The results will be saved in Excel format. Also, the
results will be continuously appended until the “Save Results” is set to off.
Figure 19
The test is run by clicking on the “Begin” button.
Summary of Contents for dc1000
Page 1: ......
