98-100 ISSUE 8
26
Fig.12
To program the test:
6. Enter the signal, frequency and bias current required for the test.
Note that the signal is normally entered as a voltage by selecting the ‘mV’ or
‘V’ button; but you may optionally enter it as a current by selecting the ‘mA’
button. (If in doubt refer to the ‘Test Conditions’ chapter of your AT user
manual.
Note also that the measure button may be used here, as outlined in your AT
user manual, with the combinations of test parameter specification shown in
the following table:
Option 1
Option 2
Option 3
Option 4
Signal
Specified voltage Specified current
Auto
Auto
Frequency
Specified
Specified
Specified
Auto
Bias
Specified
Specified
Specified
Specified
7. Select (mouse click the button) the integration time you require.
‘Medium’ is the default setting. ‘Long’ will give you more stable readings
(for tighter limits) at the expense of test time, and ‘Short’ will test at the
maximum speed, but may give slightly noisier readings.
Summary of Contents for dc1000
Page 1: ......
