C B R E a sy To o l ( VA S 6 3 2 1 A / 5 )
42
Please note:
If damage is minor, work is carried out from the center – in the case of major damage, repair work is carried out
from the outside in a circular pattern towards the center.
Use only original CBR welding tips – these are made of a special alloy. The dimensions and geometry of the tips have been
adjusted for the most effective heat dissipation and low wear.
Do not put pressure on the welding tip while welding, but apply it to the surface lightly and quickly. Start by making 3 to 4 welds
without pulling until some material builds up at the welding tip –- the weld will hold better and there will be less wear on the
welding tip!
Do not make too strong a pull – it is preferable to carry out many small pulls rather than a few strong pulls, as these results
in a better surface quality! The CBR EasyTool allows for subtle and precise restoration of the surface, and putty and filler
work is reduced to a minimum.
13.3 Program setting with the CBR EasyTool
Press “Program 3” and “AUTO” and if necessary make a fine adjustment to “TIME” and “POWER”.
Adjustment of the EasyTool handles to fit individual hand size.
