C B R L i n e To o l ( VA S 6 3 2 1 A / 6 a n d VA S 6 3 2 1 A / 7 )
36
12.1 Working with the CBR LineTool
When working with the LineTool, the same procedure, process and instructions apply as with the StrongTool.
With any extensive damage to doors and side panels, it is important to start at the bottom or strongest line (bead, edge).
This area should, however, not be completely reshaped right away; work should be carried out first on the upper and then
the middle line.
Important:
When working with the single feet and positioning them on an edge, it is essential to ensure that the support point
is exactly in the center of the feet. If the support point is outside the center of the feet, they could break under high pulling
forces due to the bending moment.
The feet may only ever be put under vertical pressure when pulling – whenever a transverse pull is performed it is essen-
tial to use the double feet.
Incorrect
Incorrect
Correct
Foot must be placed central to the edge.
Correct
Foot must be placed central to the edge.
Important:
Very high pulling forces can occur, especially with the short LineTool. This makes it all the more important to use
the straight and split double feet at the correct angle to the direction of pull.
Place the suction cups of the LineTool in the desired position and press them onto the cleaned surface using light pressure.
Fix the length with the blue line.
